I get an error message that "Running CorelDraw not found" when I launch Cutting Master 2 from the Application Launcher. The Registration Mark launcher doesn't work either.
I uninstalled my old version of CM2, and downloaded the newest, but still get the error message. I pulled up my old X3 Draw, and CM2 still works with it. Did I miss something during the X5 installation?
Thanks for any help,
Pat
Pat,
Do the plugins support CorelDraw X5? Many macros only run on certain versions. Check with the creator of the macro to see if/when they will be supporting X5.
Frank OlivioAmiGraphics
Your program may copy a gms file to your GMS folder when installing. Since your program doesn't support X5 yet (most likely), it doesn't copy over the needed gms file to the X5 GMS folder. You can get the gms file from your X4 GMS directory and copy it over to your X5 GMS directory. Then test to see it it works.
-John
Pat Wilson said:Maybe a Cutting Master support issue as Frank suggested.
Hi.
It most likely is. You may need a new version for it to work with x5.
You can still try though.
Make sure you restart x5 so you see the gms file. Drag it to a menu or assign a shortcut key.
Start your cm program in x3. While it's running, test in x5 by clicking the macro shortcut you created.
Also try drag and drop from corelx5 to cm.
If you can get it to work that would be great.
Have you folks checked out the Macro Manager docker yet?
T.
Tony Severenuk said: Have you folks checked out the Macro Manager docker yet? T.
Oh, yeah! That is one great docker, for those that have a collection of macros.....I found that the macros that I do not use everyday, and do not keep on a personal tool-bar, are easily found and executed from the docker...
Oh, and relative to Hugh's point, the CutPlot will not launch from the docker, but the others will
p
The Macro Manager loads a macro once per session. So if you need to use that macro again you'll need to reload that particular macro into the current session.
That particular macro that's not launching may need to be revised to work with X5.