I throw this out to the Masters here.... I use Corel X3 to cut vinyl and am having problems with Macros. Corel opens fine but when I attempt to run the cut Macro it locks up and tells me it cannot run the macro... It has run it in the past just fine... but of course its crunch time at the shop and now the problems begin... Help??? Please??
Tried re-installing cut master software... still no help... Anything would be appreciated...
J Peter Mock
First, try holding down the F8 key while starting CorelDRAW, and answer "Yes" to resetting to factory defaults.
If that does not work, then put the CD in and go to the install selection and then do a 'Repair'. See if that cleans up your VBA problem.
'Preciate the response. I should have mentioned that was the first thing I tried... F8 to reset and repair.... This Cut Macro always seems to lock up and error... sigh
Have you checked with the vendor for that macro?
Also try another cable from PC to Cutter if avail.
JP Mock said: 'Preciate the response. I should have mentioned that was the first thing I tried... F8 to reset and repair.... This Cut Macro always seems to lock up and error... sigh