I was trying to put some holes along a path and the curved areas and top didn't come out right but the sides look fine. I was wondering if anyone could help me with this and give me some guidance.
Thanks,
Ryan
If I check the rotate all objects then it makes it worse. What do you mean about rotate one object at the start or end?
Ryan Seeley said: I did the following in this order... 1. made a .125" hole 2. used step and repeat to get three holes at .25" apart 3. grouped those three holes 4. made a copy of that and moved it over a ways 5. selected both of the grouped holes and then went to the blend docker
I did the following in this order...
1. made a .125" hole
2. used step and repeat to get three holes at .25" apart
3. grouped those three holes
4. made a copy of that and moved it over a ways
5. selected both of the grouped holes and then went to the blend docker
6. Bleng along full Path
7. Rotate all objects
Then what do you get?
I get this...
Thanks everyone for your help!!! I was able to figure it out once I learned how to do the rotating of the start and finish groups.
You're Welcome...for my part
Mike