Hello all,
I have problem when I open some dxf format from autocad.
For each line in autocad in coreldraw I have about 10 lines. How to clean drawing?
Please help!
Wow, tool works great!
Only problem is when objects are combined (which is in my case) so I must do "break curve appart" for each object. Can You add this function?
I draw jig saw puzzles in CorelDRAW and each piece overlaps adjoining pieces on all four sides and are connected at multiple nodes. When sending to the laser for cutting, each side of each piece gets cut twice due to the overlapping lines. I was hoping the RemoveUnderlyingDups and NodeClean macro would help take these overlapping lines and create either individual horizontal and vertical line segments from the connected nodes so the laser would make one continuous cut rather than duplicating all the cuts. However, after running the macros, even on a small portion of the puzzle, I didn't get any results. I combined then broke apart as mentioned and still no joy. The only way I have been able to create separate line segments is to cut apart at the nodes and delete individual line segments... on 1250 pieces, with four sides and all sides overlapping, that's 10,000 separate edits... needless to say, duplicate cutting by the laser is faster.
Ideally, being able to create continuous horizontal and vertical lines based on corner node connections, would be the best. At that point, I could cut a 1250 piece puzzle with just 50 continuous horizontal lines and 100 vertical lines.Regards,Dave