Hi All
Having a bit of a nightmare. My trusty summa cutter has stopped working in the middle of a job but I have a spare graphtec cutter that i have never used before
I am trying to get it to cut from X4 and in the manual it says that cutting master 2 will appear in the application launcher.
I don't have this in my toolbar for some reason and I can't wirk out how to get it there
Cheers guys
mamos
Hi Mamos,
assuming X4 has it in the same place as X5 - when you go into Commands it is listed as Launcher rather than Application Launcher (its full name). Please take a look at my screen capture below.
Best regards,Brian.
You are a
Thank you very much.
I have been going through all those lists looking for 'Application Launcher'. I never thought of searching for Launcher
Thanks again