Hi All
Having a bit of a nightmare. My trusty summa cutter has stopped working in the middle of a job but I have a spare graphtec cutter that i have never used before
I am trying to get it to cut from X4 and in the manual it says that cutting master 2 will appear in the application launcher.
I don't have this in my toolbar for some reason and I can't wirk out how to get it there
Cheers guys
mamos
Hi Mamos,
assuming X4 has it in the same place as X5 - when you go into Commands it is listed as Launcher rather than Application Launcher (its full name). Please take a look at my screen capture below.
Best regards,Brian.
You are a
Thank you very much.
I have been going through all those lists looking for 'Application Launcher'. I never thought of searching for Launcher
Thanks again
mamos said: You are a Thank you very much. I have been going through all those lists looking for 'Application Launcher'. I never thought of searching for Launcher Thanks again mamos
I am really glad I could help, Mamos. To be honest with you the only reason I found it was because my icon was already on my Toolbar. All I had to do was click on it when I was in Commands and it jumped right to where it was stored. At least we got it sorted.