CorelDRAW X5 Setting the default zoom level in X5

Setting the default zoom level in X5

When I open a project in X5 (either DRAW or PHOTOPAINT) it comes up at zoom level of 100%. I would like to change this to fit page but can't find the place to set this default. Thank you in advance for any help.

0 Dustin Spears over 7 years ago

I have the same issue with DRAW X8. It's too bad you haven't received a reply in nearly 4 years.
Cancel
Up 0 Down

Reply

Verify Answer

Cancel
0 Dustin Spears over 7 years ago

I have found the best way to do this is to change the page size to encompass all objects (in my case about 600in by 600in) so that the beginning zoom starts at page size, which my program does by default, thereby showing everything at start.
Cancel
Up 0 Down

Reply

Verify Answer

Reject Answer

Cancel
0 Chris over 7 years ago in reply to Dustin Spears

You could just push the F4 key when the document opens ;)
Cancel
Up 0 Down

Reply

Verify Answer

Cancel