I have a document of 34 pages with page numbering. how can i curve all page numbers? if i curve one page number say 25, all pages get numbered as 25.
Hi rock1,
I just tried the same thing on a 12 document and got the same result as you.
I then had a 12 page document and a small rectangle on each page and published to PDF and I selected all text as curves and and saved the PDF and the PDF imported back into Draw and all page numbers were intact no problem.
Then I checked the object manager master page and no page numbers.
Then I checked each page and found that their is a copy of the page numbers like number 1 on top of number 1
If you click and drage over each page to select the 2X number 1 and group or just delete 1 of each number.
I will report this to the correct people to have it fixed.
Joe
elkhans said: Hi rock1, I just tried the same thing on a 12 document and got the same result as you. I then had a 12 page document and a small rectangle on each page and published to PDF and I selected all text as curves and and saved the PDF and the PDF imported back into Draw and all page numbers were intact no problem. Then I checked the object manager master page and no page numbers. Then I checked each page and found that their is a copy of the page numbers like number 1 on top of number 1 If you click and drage over each page to select the 2X number 1 and group or just delete 1 of each number. I will report this to the correct people to have it fixed. Joe
thank you sir :)
Hi,
For the time being this is the alternate way i use to send job to press.
After the project is complete, I save the file in X6 version. Make a copy of the file. Open the file in X6, add one blank page at the beginning. In page number settings start page numbering from page 2.
Save the file in X6 and close.
Go to Tools - Macros - Run Macro... - File Converter
In Source select the folder where the copied file exists. Add the file to Converter.
Select same destination as source file. Select file type as cdr. Enable check box for Convert text to curves, set save version as required. Run the macro...