Will extrude ever work as it should?

I have been living with Extrude function's inadequacies for as long as it's been in use, but recently built a series of macros for Isometric work and the old wounds were torn open once again. The stupid thing is - it works, it just doesn't work every time. Have a look:

Basically if your shapes are separate everything is rendered properly (most of the time), but should you decide to go the adventurous route of grouping them or even just weld them together - get ready to lose some random side edges.

This seems to happen very often with the non-perspective extrudes.

Is there any hope of this finally getting fixed?

Parents
No Data
Reply Children
No Data