CorelDRAW Graphics Suite X7

CorelDRAW X7 Connect figures

Connect figures

mksteffensen over 8 years ago

Hello,

I am new to CorelDraw X7 and in this forum.

My problem is how to remove the little part (marked with red on the attached photo), without removing the full picture.

Best Regards

Mikkel Steffensen

0 Anand Dixit over 8 years ago

I hope you have the red rectangle drawn in CorelDRAW. If so 2 ways to get two different results.
1) move the red rectangle little up so that it overlaps the Egg shaped obbjects outline. Then use trim.
2) move the red rectangle little up so that it overlaps the Egg shaped obbjects outline. Remove red color so that the overlapped outline is visible. Select Virtual Segment tool and click on the outline to remove.

I think you are expecting the results you get with second way. Hope I am clear and it helps.
Cancel
Up 0 Down

Reply

Verify Answer

Cancel
0 mksteffensen over 8 years ago in reply to Anand Dixit

Hello,

Thank you very much. I used the 2. method and it looks great.

Best Regards
Mikkel
Cancel
Up 0 Down

Reply

Verify Answer

Cancel