Hello and thanks for reading this,
I am trying to design an image that will be able to be cut out on my vinyl cuter but I'm having trouble.
I have a request for a Amirecan flag with a sports teams logo on it also (down in a lower corner)
When I design the flag I'm using the wireframe view with a 2 step contour, looking for a outline cut,and then on the lower r/corner I want to put the teams logo on, it too is in a wire frame view but it needs a 3 step contour cut to do what I need.
My question is how do I weld the two together or over lap the logo over the flag to make one pattern to cut or will this have to been done in two designs?
I hope this makes sense.
Thank You
daryl
Hello Daryl; I don't know what you are using to cut with, but if you'll send the vector logo and let me know where it go and the sizes and I'll do it for you. Then you'll be able to pull it apart and see what I had done.
George ( george@Vasigns.net )
Thank you for your reply.
I'm going to use my Graphtec CE5000-60 cutter to do this job with Hartco 310.
I am sandblasting this in to the back of a 20'x30" mirror.
Thank you very much.
Daryl