I have 2 monitors, if I put the drawing area on my right screen everything is fine, if I put the drawing area on my left screen, the cursor has so much movement lag it is unusable (only in the drawing area, the area around the ribbon/command bar is fine. Is there a setting that would control this?
Hello I have this problem too. On al ASUS laptop using Windows 10.
The extended monitor is driven by the same graphic card. Some windows in CorelCAD as the Print-window or Properties-window opens and then only 1/2 part is visible and I cant move it down to see the whole window.
When I go to settings in Windows and move the relative position of the extra screen, then the windows will get 100% on the screen (on the second screen, also when I disconnect this screen before and start then CorelCAD again). When the window is 100% in the screen I can move it by clicking at the topbar of that window and move it with my mouse.
I hope there will be an update for this problem, or is it a Windows 10 issue?