Using B-Spline tool, when I need a Clamp Control Point, I move off a left-clicked node, and then click the last point again (converting the node into a Clamp Control Point), and continue drawing.
Instead of click, move off, click same point, I would like to simply RIGHT CLICK to have that node entered as a Clamp Control Point.
keith20mm, there is a modifier key that may help in your workflow.
Holding the V key on the keyboard and clicking will create a clamped control point when you create B-spline curves.
Hope this helps, Sharon
Thanks, I am looking for a one-hand (mouse) solution.