Hi, can the sharpen & un-sharpen tools in edit bitmap be restored to factory settings as I cant seem to prepare a photo for laser engraving successfully since I adjusted these and now cant adjust them back to previous settings, Thank You
I don't think I understand what you are asking, because on all the tools on the bottom left is a reset button which takes it to default. If you saved the file after applying what you did, you are stuck unless you saved it as an updated file keeping the original safe.
If you could explain it in more detail perhaps I or someone else could help you better!
Hi thank you for replying, I'll try to expain better if I can. I've managed to prepare quite a few photos successfully which have lasered quite well but I saw a hint that if you use the unsharpen button it engraves more detail into the picture so that is what I tried.the 1st engraving after I altered the un-sharpen was fine but ever since the photos that I try to prepare in corel paint in the edit bitmap just don't have the same small pixel dots that they used to which makes the engraving really poor quality. ive pressed the reset buttons which you mentioned but they only seem to take me back to a few attempts previously not right back to the stage where my photos were good. Wish could show a photo to explain better as im not good at this