Is there a way to put the text measurement on the outside of the measurement lines?
In older versions you were able to do this and I am not seeing it in this version.
Meaning, there isn't enough room between the dimension lines for the text to fit nicely, so there use to be a way to have the text come out to the side, now the only options are above, below, and in the middle.
look for this icon after selecting the dimension line
This only allows top, bottom, middle. No to the side, in older versions you were able to move the dimension text out to the side.
Here is an older drawing I did where this was allowed
Never Mind I just figured it out!
You have to uncheck the "center text between dimensional lines" that is defaulted. Jezz sorry!
You have to uncheck the "center text between extension lines" that is defaulted and then move it. Jezz sorry!