I bought 2019 and have never used it. Every time I buy a new copy of Corel Suite I end up using my old version. I even made a new Menu bar so I could read it in Win 10. The main reason I keep using 5 is because of the customization of the tool bars. So today I tried using 2019 again so I could remember why I didn't use it. I saw right away that my custom tool bars under the menu bar are one of the problems. The tools will only go 3/4s of the way across the width of the total page. They seem to stop at the point where the dockers would be when open. So anything that would be in the tool bar will not cross this invisible line and I get the little > signs to show me the one extra thing in that tool bar. I have created the same tool bars in every version of this program. It is the way I work and I don't want to have to open the tool bar via the arrow because it is one tool tool big especially when all of them would fit if the extra space was used across the whole page. Plus this is the slowest version yet. It seems to take forever for pages to open and even tools seem to lag. I hope this has a fix by now and then maybe I can move on to finding out the reason it is so slow.
you have to move the dividers to the right to allow the space to show what you need.
You're right, Myron. It's when one toolbar is too close to another one.
I have seen situations in which that was really tedious to fix, because the toolbar that needed to be moved could only be moved a little bit at a time. I don't see that happen all the time, but I have seen other users complain about it, too.
As you can see there is a lot of room and each of those >> have only 1 or 2 extra tools. The space the >> takes up would fit the tool. On my old X5 I could place each custom tool bar anywhere along the row even if I just wanted one tool at the end of the row. Not in 2019.