I have somehow screwed up my Path Tool. I have managed to turned off the visibility. I can't see/add nodes. Tiny paths show up in the dockers, but not on my actual project. I have used them before with success and vaguely recall hiding them on a previous project some time ago to see if my overall effect was correct, but now I can't get them back! I have selected show/hide about 1000 times and they just won't come back. I'm very frustrated and the "help" section provides absolutely NONE!
Any assistance would be greatly appreciated.
Hello emmy; You can reset the program by holding down the F8 key while starting the program, It will reset it to a first install, losing any special setting you may have. Good :Luck.
George