CorelDRAW 9 + Epilogue Laser

Trying to upgrade the system (HP Pavilion 8750 - Celeron 633 MHz + WindowsMe) that I've been using to control a Epilog Radius.
The new system is an Optiplex755 + 32bit install of Windows 8 + cfresh install of CorelDRAW 9.
Downloaded and installed the driver Epilog has posted for the Radius: radiuswin32.zip
I CAN send files to the cutter.
However, after selecting Print/Properties/ I no longer get the Epilog Radius Laser Setup "control panel" that use to display a menu of printing profile setups. All I get is the plain dialog below ... not as shown above.

Any suggestions much appreciated!