Several questions that I would greatly appreciate help and support on.
1. Can we open and run software Corel 2021 without connecting to the Internet? We have firewalls etc that block this production PC from getting on Internet and then won't open program successfully. Any work arounds. We obviously bought licenses,
2. Using Windows 10 and parallel/USB port technology we encounter the following when we go to print very simple Laser file to Laser V-460 system:
Quite often (while Program is NOT Opened) we select the file and then right click file and select PRINT we get several scenarios:
NOTE: When a successfully PRINT to the Laser occurs the file Drawing opens up quickly then disappears.
> File does not PRINT and it requires selecting the file again to PRINT
> File does not PRINT; therefore, requires closing out the FOLDER and re-opening the FOLDER. Then repeat steps…right click file and select PRINT.
NOTE: Time it takes to PRINT the file varies. Not always immediate. Is this Windows 10 related or USB-Parallel cable related? Previous Windows 7 (X3 version) was quite quick.
> Software opens with no drawing file and it just hangs there. Requires closing out the Program as well as the FOLDER and repeating steps mentioned above.
> This is taking up too much time to just load 12 simple files so we can move forward with production.
As far as I know, no, you must sign in, however once that's done you may disconnect from the internet and Draw will run.
It seems you went from Windows 7 to 10. Does your device have a full Windows 10 driver?
What is a V-460 laser device? A brand name might help.
David...thanks for responding so quickly. Yes had to upgrade from Windows 7 to Windows 10.
We need to use our production computers as a generic logon on the production floor and unfortunately these computers cannot access the Internet. Somehow we need to access program WITHOUT getting on the Internet. Do any of the older programs that can run on Win 10 allow that option?
Do you have any thoughts on Print problems as well. I have created a ticket with Corel awaiting info.
V-460 laser device? A brand name might help. - Universal Laser Systems Laser Engraver
Are you sure this isn't a VLS4.60.
We bought this system 15-20 yrs ago and it is a V-460 50Watt laser.
That's why I can't find any information on it. You have a mess, what version of Draw were you using?
i think i found a workaround...for printing files...open software and then select all print files then select print and we get good results. Priro software and Windows 7 you could just print files from desktop not having the program open.
We need to figure out how to open software without an Internet connection. still awaiting feedback from Corel