Hello Everyone and My Best Buddies!!!...
Hope you Folks are Doing well! Yet again, after a Long Time I am Popping-Up here to my Favorite place! Due to Circumstances I was Unable to Respond on my Earlier 2 Pending Topics. I will try to Respond ASAP.
Please download the "Arching_Text_Placement_in_CorelDraw.cdr" file from the following Link - http://bit.ly/1wUyZwy. So, how should I make that "ABCDEFGH" as Arch within the Black Color Width?
Please Help.
Look forward to hearing from you soon.
Thank you.
Creative 77
This is actually rather, no it is very easy to do.First of all you must to Fit Text to Path. It doesn't matter where or how you position the text, it will be adjusted later.Then, for all text at the bottom of a circle you must mirror both vertically and horizontally to make it run in the right direction. Do this by clicking the two icons in Property Bar when the Text is selected.Next thing is to drag the text to the bottom of the circle, which is easy to do by simply dragging the red "diamond".Two things may be helpful when doing this:1. As you drag the text around you'll notice that is in not easy to make it stay in desired vertical position. What you can do is to press and hold Shift when you have found the approximately right position, and the text will stick to that position as long as you hold Shift.2. You will see a vertical red line going through the text while dragging, either on the left or right side, or the center. This line snaps to vertical and horizontal alignment points along the circle.
When you're done, you can fine tune the vertical adjustment using the box in Property Bar.You may also need to adjust the distance between characters, which can be done with the Shape tool, or via the Property Bar or Text Properties docker.(After doing this you may have to adjust the position sideways again.)
Done.
Edit: And check out Mike's link.
Ronny Axelsson said: Creative 77 This is actually rather, no it is very easy to do.First of all you must to Fit Text to Path. It doesn't matter where or how you position the text, it will be adjusted later.Then, for all text at the bottom of a circle you must mirror both vertically and horizontally to make it run in the right direction. Do this by clicking the two icons in Property Bar when the Text is selected.Next thing is to drag the text to the bottom of the circle, which is easy to do by simply dragging the red "diamond".Two things may be helpful when doing this:1. As you drag the text around you'll notice that is in not easy to make it stay in desired vertical position. What you can do is to press and hold Shift when you have found the approximately right position, and the text will stick to that position as long as you hold Shift.2. You will see a vertical red line going through the text while dragging, either on the left or right side, or the center. This line snaps to vertical and horizontal alignment points along the circle. When you're done, you can fine tune the vertical adjustment using the box in Property Bar.You may also need to adjust the distance between characters, which can be done with the Shape tool, or via the Property Bar or Text Properties docker.(After doing this you may have to adjust the position sideways again.) Done. Edit: And check out Mike's link.
Hello Mek, Ronny Axelsson and George,Please download the Updated version of "Arching_Text_Placement_in_CorelDraw.cdr" file from the following Link - http://bit.ly/1wUyZwy. So, what should I Do now?Please Help.Look forward to hearing from you soon.Thank you.
Creative77 said:Please download the Updated version of "Arching_Text_Placement_in_CorelDraw.cdr" file from the following Link - http://bit.ly/1wUyZwy. So, what should I Do now?
Please start from scratch and read my instructions in previous post carefully.