I've spent a lot of time getting my workspace where I like it in X6. When I export it the only available format is to a .xslt file. However, when I try to imort it into X7, I get this message "Valid workspace file not found at the path specified".
The X7 import shows the ability to select .cdws, .xslt, .cwf and .cfg formats, but it will not import the .xslt from X6.
Help would be very appreciated.
Bill
Hello AudubonCreek; It is never a good idea to import a different ver. work space into a newer or older ver. Just have fun building a new one.
George
Workspaces were completely rebuild for X7 and therefore you cannot move previous versions of workspaces forward to X7.
Get a nice large cup of coffee or soda, lock yourself in a room and you can have your shiny new X7 workspace knocked out in an hour, maybe two if you go nuts.
-Shelby
As Shelby said, Workspaces are totally new on X7 and it's not a good idea to import an old file. And also TheSignGuy is right: never was a good idea to import the workspace from a different version
And remember to save the workspace file you created else you may have to get another cup of coffee or Soda each time you reset with F8.
Shelby Moore said:Get a nice large cup of coffee or soda, lock yourself in a room and you can have your shiny new X7 workspace knocked out in an hour, maybe two if you go nuts.
In all the other versions, I could extend the menus from the tools on the left side and remove them to place them elsewhere in my workspace...
Can I still do this? This example was taken from X6.