Is there a way to restrict a dimension line to only measure vertical or horizontal?
I am trying to put in the vertical dimension from the center of circle "A" to the center of circle "B", however, when I select the center of "A" and move to "B" the dimension flips to Horizontal.
Is there a way to restrict this tool to Horizontal or Vertical?
Thanks, Eric
When dim. line from A to B is drawn then you can try press CTRL with left mouse key still pressed (tested on Corel Draw X5).
Best regards
Mek
Thank you so much, Mek .....
Works great in Corel Designer 4x - Apparently, I just needed to take CONTROLL (Ctrl) ..... ;)
Thanks again, Eric
You are welcome Eric, I am glad it works for you.
Best regards,