How do I make the 3-Point Curve tool to be continuous?

UPDATE:


The pic below is from a different software and it shows exactly how I need the Curve tool to be set to work (if possible). No matter where the nodes left I would like the curve to extend by itself. Thanks!

Hello everyone, not sure if this is at all possible, but is there a way to set the 3-Point Curve tool to be continuous, and instead of doing curves like this:

....to be able to do continuous curves and no matter where I put the ending nodes the curve to continue itself from there automatically, like this:

Many thanks for your help in advance!

  • Yes, just click on the node you wish to continue, drag, release, click, repeat as much as needed.

    Mike
    • Thanks for your answer Mike!
      Unfortunately I know it can be done manually as I did for this post on the second example. I just need the curve to extend itself automatically no matter where the nodes are left. I will update my question and insert a new image from different software, showing how I need it to be. Thank you so much!