Browse By Tags

  • Feature request: Conic rounds

    I'd like to request conic rounds for Corel DESIGNER. Conic rounds are a type of fillet, but instead of being derived from a circle they are derived from a cross-section through a cone. They are usually used for aesthetic reasons.

    I appreciate that…

  • Is it possible to dimension a radius corner of a shape in CorelDraw?

    I'm pretty new to CorelDraw but am ecstatic that is has a native dimensioning feature. However, the sign shop I work for does a lot of dimensioned drawings of things with radius corners and holes (like on safety signs that get grommets, and we call out…

  • Chamfer Fillet etc

    hi guys. any idea aobut chamfer fillet etc. ?

  • SHAPE TOOL PLAYS WITH CURVES

    Hi,

    Can I round corners of freely joined curves with the shape tool in a similar way to drawing solid shapes and dragging fillets(with the shape tool) on them?

    Thanks,

    Mike

  • Outline corners of curve (former rectangle) points are fixed to bevel

    To reproduce this behavior: create a rectangle, add some corner radius to all 4 points (or convert it to curves and add some fillet to all 4 points). Now add some point on a straight segment and move it away from the figure. The corner is fixed to bevel…

  • RE: Inconsistent edge-face relationship for fillet build.

    Thanks Cj7hawk.

    I have taken all your great advice on board and have had considerable success. Thank you again. You are a wizard.

    Here is my new flanged plate, but I have hit a couple of snags.

    (1)  When I Select-All in the Model space, I can see from…

  • Inconsistent edge-face relationship for fillet build.

    In this dwg I have been building a 3D curved fillet in a corner where two flanges meet. I use a special method to make this to ensure the fillet follows the radii of the adjacent flanges in the perpendicular planes, which share a common magnitude of radius…

  • Filleting a curvilinear corner of 3D Solid Flange

    My problematic flanged plate, when being made by hand by the sheetmetal worker, needed to have a 0.08 (or 5/64) in diameter  relief hole drilled between the corners of the flanges to prevent the 0.040 in thick Alclad sheet from developing a crack there…

  • CNC Router Artwork Prep macro

    We use Coreldraw to prep our artwork before we cut something out on our CNC Router. One of the things we have to check for everytime, is that the router bit is going to fit everywhere around the letter (inside and out) as it cuts it out. Basically we…

  • Re: Normal Z

    Hello Armin,

    here's a workaround for the problem you're describing. The developers have looked into this and suggest the following steps:

    When using the fillet command for applying round corners, check the ARC resulting by the fillet command…

  • Tip on quickly rounding corners...

    In older versions of CorelDRAW, to avoid unwanted sharp points in contours created with the Contour tool, I would first round the corners of my original shape in the Fillet/Scallop/Chamfer docker using a very small radius value, before I applied…