I have a drawing that I will be sending over to an Epilog laser to cut a sheet of acrylic. The drawing consists of 100 squares, spread across the page in a grid, each on its own layer. My hope is to assign certain print settings/preferences (such as laser cut power and laser cut speed) to each individual layer, therefore eliminating the need for me to manually change the print settings and run each individual layer's cut...
This may be on the Epilog side of things, but I thought I might ask here too in the event that others have had a similar project goal.
The following is a screenshot of my document:
try to use Epilog laser Color Mapping Settings
I would create my own color palette (based on RGB colors) in CorelDraw – each color will have its settings for laser engraving.
Then set up Color Mapping for job - this can be saved and then used as “template” in future