transparency is not applying properly for the inverse white to black gradient, check the attachment.
How do you do to get 100% black into the transparency swatch?Dragging the black swatch from the default CMYK palette will in fact not create 100% transparency. Instead it will be around 94 - 96%, depending on your CMYK color profile. To make it 100% transparent, you need to set the slider in Property Bar to 100% or use the 100,100,100,100 black at the end of the default palette.It's the same in X5 and I don't think it could be considered a bug.
Another problem though, which may in fact be why you aren't getting 100% transparency, is that for a radial transparency or fountain fill, you have to drag the outer end handle to about half the size of the expected transparency or fill, to get the result you want.This is a well known problem but I suppose it can not easily be fixed without breaking backwards compatibility.
I really could not understand, this problem arise only at black that too inversed
I mean white center & black outside. Please use radial transparency and not
the linear one. Though the black taken of 100 + 100 + 100 + 100 the its not
getting pure transparent. please verify
As Ronny stated, it works exactly as it did in X5.
No offense, but the more you try to explain an issue the more confusing it gets. I am hardly able to understand what you are trying to explain.
For me, and for most users, I believe, the radial transparency, normal or inverted, works just as expected, as it did in X5. No issues there.
my pattern fill problem is solved, but this is not. in my system
corel x5 works fine but not in corel x6.
please try in x5 by taking the image with radial transparency inversed center white and outer black color (black means C:0, M:0, Y:0 K:100). Pure transparent is coming in x5. But in x6 it is not coming. Please check this
pkg_sriram said: Pure transparent is coming in x5. But in x6 it is not coming. Please check this
Pure transparent is coming in x5. But in x6 it is not coming. Please check this
Attached a radial transparency in X6 with the values you have specified. Could you point out the problem please?
yes, yours is fine. here what happening when i have
first chosen the linear gradient, where the black is active
pure transparency and afterwards chosen the radial with
inverse (by dragging the black color from the palette).
There i found the error in the property bar the black stays
at 85%. after dragging to 100% it is ok. Why this is happening ? because
i am dragging the 100% black
It is possible that you are experiencing a variance in transparency due to the problem that I have tried to describe below:
Unpredictable variations that happen when you copy transparency properties between objects:The angle and edge pad values are not always the same. Sometimes they are correct, sometimes not. The behavior is different for each kind of transparency, ie Radial, Linear etc.
When the end handles of the transparency slider snap to nodes or angles on the object, the values of the angle and edge pad seem to copy over fine, but when they don't, the results are unpredictable. I have had to manually enter the angle and edge pad values to get the correct transparency copied.
I am hoping Ronny or someone else will be able to confirm this and state the issue in a much more understandable manner :) Ronny has a great way of describing a problem and it possible solution.
Looking forward to it. :)