Is it possible to change the direction in which the numbers grow on the rulers?

Involute
over 8 years ago

Newbie here.  I'm going to be using Corel with a laser cutter in which the origin is in the upper-left corner.  It would simplify things if I could configure my drawings the same way.  I figured out how to set the origin up there, but the y-axis increases negatively down the page from the origin; I'd like it to increase positively in that direction.  Is that possible to do?  Thanks.

Parents
No Data
Reply
  • over 8 years ago
    Precisely set guidelines to intersect at the corners you want the zero to be make sure the x & y values are exact. Then make sure snap to guidelines is on. Drag from the corner of the rulers to where you want the zero to be and it should snap to the intersection of your guidelines. Make sure you hit save settings as default.
Children

© Corel Corporation. All rights reserved. The content herein is in the form of a personal web log ("Blog") or forum posting. As such, the views expressed in this site are those of the participants and do not necessarily reflect the views of Corel Corporation, or its affiliates and their respective officers, directors, employees and agents. Terms of Use / Privacy​ ​/ ​Cookies / Terms and Conditions / User Guidelines.