Connect figures

Hello,

I am new to CorelDraw X7 and in this forum.

My problem is how to remove the little part (marked with red on the attached photo), without removing the full picture.

Best Regards

Mikkel Steffensen

  • I hope you have the red rectangle drawn in CorelDRAW. If so 2 ways to get two different results.
    1) move the red rectangle little up so that it overlaps the Egg shaped obbjects outline. Then use trim.
    2) move the red rectangle little up so that it overlaps the Egg shaped obbjects outline. Remove red color so that the overlapped outline is visible. Select Virtual Segment tool and click on the outline to remove.

    I think you are expecting the results you get with second way. Hope I am clear and it helps.