CorelDRAW Technical Suite X7 Dimension settings

Dimension settings

When I open a file all my previous dimensions gain an additional '.00' Even though I've set the decimal place to one under Tools - Options - Edit. Has anyone solved this problem before? Or is there a way to set a global state that changes the whole document?
Many Thanks :)

0 Jised over 7 years ago

Try this:
Set up decimal units (mm, cm) in Units window of Properties Bar, and then make setting: Tools - Save setting as default.

It could be work.
Cancel
Up 0 Down

Reply

Verify Answer

Cancel
0 Jised over 7 years ago in reply to Jised

I forget also write: After doing: Save setting as default, you must close the CorelDraw, and then open it again.
It could be working.
Cancel
Up 0 Down

Reply

Verify Answer

Cancel