Good day
I was wondering if anyone else has the problem of the shortcut key ctrl+z not working after X4 has been running for awhile? It still works at EDIT/UNDO. If I restart the progarm the shortcut key works for a bit then back to using the EDIT/UNDO command.
Regards,
Garrett
Garrett said: ctrl+z not working after X4 has been running for awhile? It still works at EDIT/UNDO. If I restart the progarm the shortcut key works for a bit then back to using the EDIT/UNDO command.
ctrl+z not working after X4 has been running for awhile? It still works at EDIT/UNDO. If I restart the progarm the shortcut key works for a bit then back to using the EDIT/UNDO command.
If it's not the X4 fault then I say/ask two possible things/questions:
- Do you switch your keyboard? Some keyboard layouts have Z and Y exchanged.
- Do you have an another application installed that reserves this keyboard shortcut? Ex.: recently I had an original video card utility that reserved the Ctrl-Alt-C.
Also when the problem shows up, you may want to check the Undo command's shortcut key: Click Edit, right-click on Undo, Customize -> Menu Item -> Properties.
icefront said: ctrl+z not working after X4 has been running for awhile? It still works at EDIT/UNDO. If I restart the progarm the shortcut key works for a bit then back to using the EDIT/UNDO command.
[/quote]
No it's the same keyboard I have been using all along and I have no problems with any other program that uses the Z key for undoing an actoin.