Converting an Image into a Jpeg

Export, JPEG

Note: you might need to have a no-fill no-outline object just a little
larger than your actual image in order to allow the edges of your design
to not get slightly cut off, especially if there is a border.

You can specify in the JPEG dialogue the PPI and compression factors,
etc. Be sure the PPI (pixels/inch) meets the US TM office specification,
which is not in front of me right now (did one such submission for a
client about 3 years ago, I think)

Matt_jay50 wrote:
> Good Afternoon Everyone,
>
> I am new to CorelDraw X4 and I was hoping to gain some advice on how to
> convert an image i created into a Jpeg. You see, I obtained CorelDraw X4
> with the intention of creating a label for my company and then
> trademarking said label. Unfortunately the US trademark office requires
> a jpeg image, and I have no idea how to convert my label. Any advice is
> much appreciated.
>
> Thank you,
>
> Matt_Jay50
>
>
> ------------------------------------------------------------------------
> http://community.coreldraw.com/forums/p/4081/14975.aspx#14975
>