Hi All,
I have another question for you wonderful people
Im struggling a little with something I have been able to do on numerous occasions without problem. If you take a look at the image below, what I want to do is remove the parts of the red logo below the black line. normally I would use the virtual segment delete tool. this is working with the red outer line, but not on the letters. rather than removing the part of the letter below the line, it is removing the whole letter. Also it is leaving a square edge on the line, and not removing it on an angle. I understadn why this is, but would like to know how to do this properly.
Ive got the part of the circle removed as required, its just the letters Im struggling with now. its removing the whole letter, or doing the following:
see how it has outlined the part of the E that I want to remove. Im sure Im very close to acheiving what I want, just cant quite get my head around it
Okay, this was weird but:
i finally figured out where i was going wrong. i wasnt holding shift when i selected the target object. thanks for your patience, it must be frustrating trying to teach an idiot :)
purplepanda said:trying to teach an idiot
There is no idiocy here at all, just a 'student' seeking guidance in order to understand. To be truthful many times I end up learning something new when trying to work through some of these problems. I hope your projects works out okay.