I get an error message that "Running CorelDraw not found" when I launch Cutting Master 2 from the Application Launcher. The Registration Mark launcher doesn't work either.
I uninstalled my old version of CM2, and downloaded the newest, but still get the error message. I pulled up my old X3 Draw, and CM2 still works with it. Did I miss something during the X5 installation?
Thanks for any help,
Pat
I've been busy lately and haven't had a chance to mess with x5 much. The docker sounds cool. If the gms is in the docker I would think it would show up in the customize commands area.
Can you activate it from the docker? What else can you do with the docker?
-John
RunFlaCruiser said: I've been busy lately and haven't had a chance to mess with x5 much. The docker sounds cool. If the gms is in the docker I would think it would show up in the customize commands area. Can you activate it from the docker? What else can you do with the docker? -John
From the New Macro Manager, You can load any directory with the GMS files in it. There's no need to have it in the traditional GMS folder. It great when you have alot of macros that do different things.
The Macro Manager also lets you record, edit, create, etc. your macros.
Here's the response from Graphtecamerica:
Pat,
The current release of Cutting Master 2 v1.60 does not support X5, and when we do release it, it will be downloadable from our website under support at www.graphtecamerica.com thank you,
You'll just have to use X4 until that happens... what a bummer :(
Are you (or anyone) able to use Cutting Master 2, v1.80 with CorelDRAW X5 and Service Pack 2?
After installing SP2 I found that I can no longer run Cutting Master with X5, even after a reinstallation.I get the same error "Running CorelDraw not found" message you got before Cutting Master was updated for X5.
Anyone?