When doing INSERT PAGE, default units are inches (I am using mm as a default unit).
Can I change that?
Try using the Insert page at the bottom, just right of the Page number to insert a page after the current page, or the one on the left of the Page number to insert a page before the current one.
EDIT: Excuse me. It was very late and I did not notice I was in the CorelDRAW X5 Forum. I do not know if Draw X5 has this. I was using DRAW X4. Leaving this just incase.
Kursad
I observed that this happens only when Custom Page size is selected. IMO this is right as the user has chosen a custom page. However it would be nice if DRAW reads the current UOM and displays accordingly. It could be an enhancement in my opinion.
Kursad Cakir said: 2. Change the page size to custom size
1. Create a new page
2. change the units to mm
3. At the top of the screen click the menu named Tools
4. click in the tools menu Save Settings As Default
Skip steps 3. and 4. by doing the following: press and hold the "ALT" key and press "o" and then press "d" and then release the "ALT" key.
Now all your new inserted pages will be in mm :)