how can reconect PP with Draw, have no edit mode in Draw?
Have a look at http://community.coreldraw.com/forums/p/45092/215270.aspx#215270 which is probably the problem that you have.
I posted there, but no one answer and did not work for me?!?
Hello Erik; You don't have in info in your Bio on your home page about your computer or Windows. It will be best to go to the post that Harry is pointing to click on AndrewC's avatar and get his email address and email him, make sure you give him the the info for your setup.
George
I just did, thx
Erik, your problem is that the "Edit Bitmap" option in CorelDraw is disabled when you have a bitmap object selected?
(There are a few problems discussed in the other thread)
Yes that's correct!
Ok,
Erik said: Yes that's correct!
Ok, then we just have to work our way through these steps.
1) what is the value of this key?
HKEY_CLASSES_ROOT\.CPT
(Should be "CorelPHOTOPAINT.Image.17")
I see from your last post that you changed thi, I believe to "CorelPHOTOPAINT.Image.17""
2) Assuming 1 was correct, can you look up this key:
HKEY_CLASSES_ROOT\CorelPHOTOPAINT.Image.17\CLSID
Should be a long guid here,
{a43cbf70-0ffa-3a89-42f9-11edfed78598}
Can you confirm this, Erik?
3) If everything is ok so far, then have a look here:
HKEY_CLASSES_ROOT\CLSID\{a43cbf70-0ffa-3a89-42f9-11edfed78598}
You should see a LocalServer32 key with the value pointing to your PhotoPaint executable.
Can you confirm this one too?Thanks,Andrew