When I used a non-standard font size in Corel Draw X8 (e.g. 10.5), the font size was shown in the drop down menu and could be easily selected for other text in the same document. In Corel Draw 2018, the used font sizes are not shown in the drop down menu any more. Is there a possibility to activate this functionality in Corel Draw 2018?
I'll have to double check but when I use font sizes in increments less than full points the drop down recognizes that size in the drop down when I use that font. Not just when select the type that was set to a partial point size At least that's how remember it.
Yes, that was the behaviour with Corel Draw X8. But with new installed Corel Draw 2018 the drop down menu does not recognize the size of a used partial point size in the drop down (at least on my computer).
The question is, whether it is just a local problem of my installation and if so, how to solve it?
Matthias said:Yes, that was the behaviour with Corel Draw X8. But with new installed Corel Draw 2018 the drop down menu does not recognize the size of a used partial point size in the drop down (at least on my computer).
Matthias said:The question is, whether it is just a local problem of my installation and if so, how to solve it?
I see the same behavior that you see.If I use a font size that is not in the list, then CorelDRAW X8 adds that font size to the list for that session of CorelDRAW. The list goes back to the default the next time I run CorelDRAW.CorelDRAW 2018 does not appear to have that "modify the list for this session" capability.