Hi Guys, probably a simple solution to my question, but I can't seem to give an object a contour of less than 1mm nor can I resize an object to less than 1mm. Is there a setting in tools I'm not seeing?
Have you checked the "Drawing precision"?
Hi, yip, it's set at 3 decimal places, but still no luck.
Yeah, me too..Ha ha
Corel want screen shots or video to try and understand it too
Well, someday it might make me look like a genius when someone else has the same problem!
Is this something where you are trying to enter the values into boxes by typing? Does the same limitation apply if you try to change the value (e.g., contour size) by using the spinbar controls?
When trying the contour it only happens when I input the value and it's less than 1mm.
Resizing an object it's also when I'm trying to make it smaller than 1mm by inputting the value.
So it's basically not wanting to do anything smaller than 1mm
Does it work correctly if you enter a value greater than 1 mm that has a decimal point in it, e.g., 1.75?
I have heard of cases where people were having problems based on regional settings for whether commas or periods were being used as the decimal separator.
Just checked - It only allows me to go up or down in 1mm increments