Cut Contour not pick up in color choice for my roland

Treela
over 8 years ago

Hi room

Here is my issue. I have the CutContour set up correctly in my Corel X4 ***(Thanks You Myron)*** and I have tried several times to export it to my Color choice program that runs my roland cj500. 

It prints just find but doesnt pick up the contour cut. I really need help with this, by reading some of the other post I should be exporting using EPS. ????? I was looking at the advance bar and it has a area (Spot Colors) and the box is not check for convert spot colors to process... should that be checked????? If any one has any experience with color choice as well any help would be very much appreciated. I thought I had my color choice set up correctly but since i am so new to this I could be wrong. 

Theresa

Parents
No Data
Reply
  • 0 over 8 years ago

    Treela said:
    It prints just find but doesnt pick up the contour cut. By reading some of the other post I should be exporting using EPS?

    There are limited ways to get art out of Draw to another software that retains spot colors and RGB/CMYK inside the same file. I'm not familiar with color choice.... There should be resources at Roland to show what's necessary to to get art into it that retains the CutContour spot color.

Children
No Data

© Corel Corporation. All rights reserved. The content herein is in the form of a personal web log ("Blog") or forum posting. As such, the views expressed in this site are those of the participants and do not necessarily reflect the views of Corel Corporation, or its affiliates and their respective officers, directors, employees and agents. Terms of Use / Privacy​ ​/ ​Cookies / Terms and Conditions / User Guidelines.