I'm somewhat new to CorelDraw and this may be a silly question, but i cannot find any help on this issue elsewhere. I have created an 11x17 drawing but when i go to the print vierw, it shows somerthing like 10x11 (the 11 starts at 3" and goes to 14")
When i print, the printer (Xerox WorkCenter 7345) selects the correct paper (tabloid) but it prints as though it's on 8x14 paper.
I can print to the Xerox with other programs on the 11x17 paper without issue. Any ideas?
Thanks
Based on your description, I would guess that you have not set your paper size and/or orientation in the Print Setup. Print Preview is most helpful in discovering these mistakes. I do not use X5, but you should be able to find Print Setup under the File Tab.
Thanks for the idea, but the Print Setup is the same (set to 11x17, landscape) as in other programs. For example, Microsoft Word sees the size fine and prints without issue. I guess I'll just use Word for this project.
Thanks,
Ed
Hello ecjjjr; Like Jack said set the page in Corel to 11" x 17" in. That can be done in "Layout"
My Thoughts George
George,
I checked the Layout and it is set to Tabloid, 17x11, landscape. When i show margins or go to print preview or print, it still only uses a portion of the 11x17 paper and screen. Thanks for helping...
ecjjjr; the printer driver in Windows is what Corel uses to print, if the page in Corel is at the 11x17 in. setting it should print it. You may want to check to see if you have the latest driver for the Windows you are using ( and good luck with the Xerox I've used them and It is the last printer I would buy. )
George
I agree and that is my issue. The page in edit mode is 11x17. As soon as I go to print preview, it shows 10x11 (the page physically starts at 3" and goes to 14" wide). I have tried printing to Word using 11x17 on the same PC and it works fine, so I'm not sure if it's a print driver issue but i'm open to suggestions.
Here is what i am seeing, so what the heck am i doing wrong...LOL?
EDIT
PRINT PREVIEW:
I can't say were I see you doing anything wrong but maybe missed something? And you may want to try the reset for Corel ( hold down the F8 key while starting Corel that will reset it to the out of the box settings. ( If you have any settings that are not stock they will be replaced. ) I do see where you have one issue in the print opshions? And you may want to try the fit to page