Hi!
I have a design and I need to change part of it a different color. It is one design, so in order to change the color do I have to break it apart? Because I'm using the design for a vinyl cutter would I then need bring things to the front and do the front minus back on it all again? I hope this makes sense, when you break a design apart it messes all the parts of it up esp for cutting.
I have never been able to figure out how to change just part of a design without breaking it apart.
Thanks,
Tracee
Hello Tracee; If you are just going to change the color in a singe line drawing you can use a interactive fill or you could use a mesh fill. It's not to hard in X6, but it's real easy in X7. You may want to try the 30 trial, but don't for get to back save any drawings to X6 before the 30 days are up.
George
Thank you George. If I use the interactive fill tool will it cut that twice because the black is still under it?
I have X6 because I also do Rhinestones, and 7 doesn't work with the macro I use for Rhinestones.
Thank you!