I was trying to put some holes along a path and the curved areas and top didn't come out right but the sides look fine. I was wondering if anyone could help me with this and give me some guidance.
Thanks,
Ryan
If I check the rotate all objects then it makes it worse. What do you mean about rotate one object at the start or end?
Did you "Group" the three circles (start and finish) first before blending and Rotating all?
I did the following in this order...
1. made a .125" hole
2. used step and repeat to get three holes at .25" apart
3. grouped those three holes
4. made a copy of that and moved it over a ways
5. selected both of the grouped holes and then went to the blend docker
Ryan Seeley said: I did the following in this order... 1. made a .125" hole 2. used step and repeat to get three holes at .25" apart 3. grouped those three holes 4. made a copy of that and moved it over a ways 5. selected both of the grouped holes and then went to the blend docker
6. Bleng along full Path
7. Rotate all objects
Then what do you get?
I get this...
Thanks everyone for your help!!! I was able to figure it out once I learned how to do the rotating of the start and finish groups.
You're Welcome...for my part
Mike