In X5 Draw and Paint my tool-tips have stopped showing and I can't see where they could've been disabled.
Any ideas?
Steve
Mek
Mek,
This was set. I cleared and reset it but still no tool tips.
Steve.
Hi.
Maybe a restart of the computer.
Or on a long shot try switching themes and then back again. It could be a windows Glitch.
~John
Guys,
Thanks for the help but I have major problems as Corel started to crash when opened. I uninstalled and reinstalled but this didn't fix it and I have now found many apps crashing on opening so this is a system problem.
64 BIt Windows 7. Tried the memory test and it hung at 21% for literally hours. May have a h/w fault.
Hi, It is a memory glitch because you install the wrong memory to the system.
you should check the memory compatibility with the memory manufacturer like Kingston.com.
And take the non compatible memory out and replace it immediately.
Hello Steve; After a clean reboot go into the Computer Setup ( most of the time Ctrl+Alt+Del )( The computer Bios ) and reinstall your ram. All the ram Should match when you install it. ( It doesn't work well if you have different types of ram install, even by the same bran name. ) It doesn't help to have faster ram than the mobo can use. The Bios ram test at start up can checks it for you, it just takes a little time.
Good Luck.
George
That post is over two years old!
HaHaHa I hope you have it taken care of then.