Hi
I'm trying to print a flier on A6 paper on an HP CP1515n. I set the paper size in Corel 12 to A6, then set the paper size on the printer to A6. The paper feeds through very nicely - with nothing on it.
It works fine printing from MS Word so I am placing the paper correctly.
Using XP Home Edition SP 3
Please - any help you can give me would be most appreciated. I am currently printing on A4, then cutting into 4. I have found a cheap source of A6 paper but can't get my fliers to print.
Reset your workspace, Hold F8 While the program starts.
You will however loose any customizations you have done.
Still nothing.
I think I'll try A5 and see what happens.
As a possible consolation ... I suspect that by printing as 4-up on A4 you may be using half the toner that you would use printing four times as many copies on A6.
I'm not totally certain but I think the printer probably applies toner to the full width of the drum even if it has only imaged to half of it, and the rest probably ends up in the waste toner bottle.
Anyway, back to the problem ... when you load A6 paper, does it feed in the centre of the printer or down one edge?
harryLondon said: As a possible consolation ... I suspect that by printing as 4-up on A4 you may be using half the toner that you would use printing four times as many copies on A6.
You would save print time. Not sure of total time since you would still have to cut the output. Each page printed requires up to 4 passes, one for each toner color. Printing 4 up would require the same number of passes and although each would take a little longer, it would be less than printing four A6 prints
harryLondon said: I'm not totally certain but I think the printer probably applies toner to the full width of the drum even if it has only imaged to half of it, and the rest probably ends up in the waste toner bottle.
Actually Harry, the toner is only deposited on the drum where it is needed.
Hi nextdoor,
If you can print to PDF.
Save the Draw file as a PDF and print that PDF and see if it will work.
Joe