Hi Ronny (and anyone interested),
attached is the latest update of the FREE BDSwapImage macro. The latest version has built upon the QuickSwap module (select 2 images and then swap them with one click) by adding a QuickSwapSize module which not only swaps 2 images, but also swaps their sizes.The macro also has the original module SwapImage module which pops up a userform and allows the user to choose how the 2 images are swapped (e.g. swap the position of their top left corners, bottom right corners, etc). Here is a screen capture of how the modules appear in the Macro Manager docker, assign shortcut buttons/keystrokes to make them one click away:
Refer to the video below to see the intented use of this macro:
Brian said:.The macro also has the original module SwapImage module which pops up a userform and allows the user to choose how the 2 images are swapped (e.g. swap the position of their top left corners, bottom right corners, etc).
hi Brian,
Looks good. FWIW, this functionality has been in the commercial Dizzy shaping macro since 2007, and it also includes all alignment and transformation options. Plus much more...
Jeff Harrison said:FWIW, this functionality has been in the commercial Dizzy shaping macro since 2007, and it also includes all alignment and transformation options. Plus much more...
Hi.
Yes. That's one helluva macro. Very handy.
Do you guys use this image swap feature a lot?
-John
I contacted you a while back about your WorldScale macro. user names Gorgo/Gorgo2 in forums.oberonplace.com
-Greg
ggut said: I contacted you a while back about your WorldScale macro. user names Gorgo/Gorgo2 in forums.oberonplace.com -Greg
Hi Greg,
ah, are you the one who was going to modify it to your needs? If so, how did that go, did you manage to pull off what you needed?
Best regards,Brian.
So far so good.
looks good!! Are those ruler images acting as buttons to set presets in the macro, or are they just images to remind the user of the common units which should be used? If you chopped those images up into smaller images, each could act as button to action a preset for the user.
yep. Each one is a button/image.
ggut said: yep. Each one is a button/image.
Nice!
Slowly getting there, just doing a bit here and there when I get a chance. Here is the next step in my Styles macro:
Naturally, I am going to add page numbers to the table of contents, and any of the macro's styles can be used to style the table of contents.
This is another idea - a macro to track time spent on a job. Press Start Job and off she goes. Press stop when taking a break or doing something else, then press Start again. Click End Job when done and the macro creates a new layer on the active page of the document with a report. The report shows original time/date job started, the finish time and all the clock in/clock outs (when you pressed start/stop). The layer created is set to non-printable.
This needs to be a standalone application in case CorelDraw crashes, which would cause the built-in macro to crash too. I will build a standalone version and attempt to add features like tracking more than one job at a time and being able to close the macro and restart it later without losing data. I had to start somewhere and this is it:
Brian said:This needs to be a standalone application in case CorelDraw crashes, which would cause the built-in macro to crash too. I will build a standalone version and attempt to add features like tracking more than one job at a time and being able to close the macro and restart it later without losing data. I had to start somewhere and this is it:
Alex, a Corel Employee, made something like this many years back, check this.