So, first off, I have 2 lasers that run off my one computer. An Epilog Legend 36 EXT and and an Epilog Zing 30 watt. The Legend works just fine but I have found that for some reason with the Zing my artwork is getting compressed. For example - I'm lasering a plate that is 8" wide by 4" high and when it's lasered comes out 7-1/4" high by 3-1/4 high. I tried shutting the machine off - restarting CorelDraw ... I'm just not sure where to go or look to try and fix this. Anyone have any experience with this?? or am I just nuts!
pea0470 said:the Zing my artwork is getting compressed. For example - I'm lasering a plate that is 8" wide by 4" high and when it's lasered comes out 7-1/4" high by 3-1/4 high
Is this after the Windows 10 update?
If so, you have your answer.
Look for an updated driver or roll back to previous version of Windows.
Not much help but the truth.