I am making circle templates divided into equal pie shaped sections, to be used as templates in my production shop. It works very well when I make eight pie shapes in equal size.
Problem: When I divide the circle into ten equally sized pieces – I can not separate them individually from the circle form.
I use:
Please help – I’m going nuts here.
Stig.
I'm not sure if this is the easiest or fastest way, but I used the smart fill tool to define the separate pieces of pie.
Diane.
Thanks for your rapid reply. Your solution looks interesting. I think that I did something similar, as I explained in the first and only post at this forum. I am new at this as you can see. A ten section pinwheel or radial division is what I am shooting for.
I typed down the word “pinwheel” in search and to my delight I found out what I had been looking for all of last week. It is a file written by you, May 15, 2007. The second I saw it the proverbial light clicked on. I went into a new file, typed in 36 degree for the angle and rotated, as you described. Bingo – there it was!
Perhaps you are a genius? Worth pondering, I think so.
Thanks again.
Hi,
I have divided the circle into 12 sectors and I want to add the contents into the sectors, I am not able to do that kindly help with the issue.
Thank yu